АвтоКлуб любителей и владельцев автомобилей Сатурн ВЬЮ - SaturnVUE-Club.ru - OWNER Club Saturn Авто разборка Сатурн, авторазбор запчасти, б/у автозапчасти, разбор автомашин SL, VUE, Автосервис, СТО, ТО, Магазин САТУРН SATURN VUE
Forum -! ПИШЕМ ВСЕ ТУТ ! (Форум Клуба SaturnVUE-Club.ru) => Ремонт и эксплуатация Saturn VUE => Topic started by: serg-mos on 19-04-2012, 22:06:14
Title: Ошибка Р0171
Post by: serg-mos on 19-04-2012, 22:06:14
сегодня вылезла . бедная смесь для начала предыстория легкие провалы, рывки на ходу появились давно, еще прошлым летом. в итоге не ехала совсем, особенно в гору но сама ошибка не вылезала поэтому грешил на варик, который в итоге поменял..))) сегодня начал эксплуатацию с новой коробкой, на холодную все ок, но вот потом... все стало повторяться.. все тоже самое!!! варик оказался ни при чем (вниманию тех, кто хочет прикупить, есть АБОЧИЙ варик!!!!) ;) но вопрос то в другом, как бороться с этой ошибкой, которая теперь реально блымбает на сканере на других форумах начитался всего такого, что даже в голову не пришло б.. например, грязная лямбда!!! первая.. ого! кто у нас сталкивался с таким и как справился? буду благодарен за советы
Title: Re: Ошибка Р0171
Post by: sasha on 19-04-2012, 22:58:48
У меня такое было,после замены фарсунок,всё прошло,кстати ставил от волги.
Title: Re: Ошибка Р0171
Post by: dеn812 (Денис) on 19-04-2012, 23:44:36
может помыть форсы?
Title: Re: Ошибка Р0171
Post by: sasha on 20-04-2012, 00:54:13
Я пробовал мыть,сам не вымыл,а в мастерских столько просят,что дешевле волговские новые купить.
Title: Re: Ошибка Р0171
Post by: sergey on 20-04-2012, 01:55:08
1. Did you perform the Diagnostic System Check - Engine Controls? If yes, go to next step. If no, go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS . 2. Install scan tool. Start engine. Operate vehicle within the Conditions for Running the DTC. See CONDITIONS FOR RUNNING DTC . Record the LT FT Cruise/Accel and LT FT Idle/Decel parameter values. Turn engine off. Turn ignition on, with engine off. Review the Freeze Frame/Failure Records and record displayed data for this DTC. Does the scan tool indicate that the LT FT Cruise/Accel parameter is more than 23 percent? If yes, go to step 4 . If no, go to next step. 3. Does the scan tool indicate that the LT FT Idle/Decel parameter is more than 8.1 percent? If yes, go to next step. If no, go to DIAGNOSTIC AIDS . 4. Operate engine at idle. Observe the front HO2S parameters with a scan tool. Does the scan tool indicate that the values are within 200-800 mV and fluctuating? If yes, go to next step. If no, go to step 6 . 5. Turn engine off. Visually and physically inspect vacuum hoses for splits, kinks, and proper connections. Ensure that the vehicle has sufficient fuel. If fuel pressure is too low, this DTC may set. Did you find and correct the condition? If yes, go to step 8 . If no, go to step 7 . 6. Turn engine off. Inspect the HO2S for proper installation. Verify that the electrical connectors and wires are secured and are not contacting the exhaust system. Did you find and correct the condition? If yes, go to step 8 . If no, diagnose fuel system. Refer to FUEL SYSTEM DIAGNOSIS under FUEL SYSTEMS in BASIC DIAGNOSTIC PROCEDURES - 2.2L & 3.0L VUE article. 7. Operate the engine at idle. Inspect for missing, loose, or leaking exhaust components. Inspect for vacuum leaks at the intake manifold and injector "O" rings, air induction system and air intake ducts for vacuum leaks, or crankcase ventilation system for leaks. Check for a skewed MAF sensor. Did you find and NOTE: If any DTCs are set other than DTC P0171 or P0174, diagnose affected DTC (s) before continuing with test. Refer to DIAGNOSTIC TROUBLE CODE DEFINITIONS . correct the condition? If yes, go to next step. If no, diagnose for an engine mechanical problem. 8. Clear the DTCs with a scan tool. Turn ignition off for 30 seconds. Start engine. Operate vehicle within the Conditions for Running the DTC. See CONDITIONS FOR RUNNING DTC . You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records. Did the DTC fail this ignition? If yes, go to step 2 . If no, go to next step. 9. Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? If yes, diagnose affected DTC(s). See DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no DTCs are displayed, system is okay. Diagnostic Aids ???? A skewed MAF sensor may set this DTC. Refer to DTC P0101: MASS AIRFLOW SYSTEM PERFORMANCE . ???? System will go lean if an injector is not suppling enough fuel. ???? A skewed ECT may set this DTC. ???? System will go lean during high fuel demand. ???? Review the Failure Records with a scan tool. If an intermittent condition is suspected, refer to INTERMITTENTS in TROUBLE SHOOTING - NO CODES - 2.2L & 3.0L VUE article.
Title: Re: Ошибка Р0171
Post by: dmitriy40rus on 23-04-2012, 16:53:54
Я пробовал мыть,сам не вымыл,а в мастерских столько просят,что дешевле волговские новые купить.
саш будь добр написать от какого мотора волги. на волги какие только моторы не ставили, змз 406,405,409,донс крайслер и т.д. и т.п. форсунки то все разные. и каталожный номер бы не плохо.
Title: Re: Ошибка Р0171
Post by: Nik-a on 23-04-2012, 19:23:58